Description

By making the rear suspension of MC-1 A-arm specification, it is possible to freely adjust the toe angle change at the time of bumping in addition to the vehicle width, camber angle, caster angle, roll center, and the setting range is wide. It spreads.
You can try various settings according to the road surface condition and layout of the course and the driving style.

Please try the rear A arm conversion set that brings out the performance of MC-1 even more!

■ Contents (* Please refer to the lower parts list for details of each part)
・ Aluminum rear rear arm (1 each on the left and right)
・ Aluminum rear rear arm plate (2 pieces)
・ Aluminum rear upper arm (built-in ball bearing, Left and right 1 each)
・ Aluminum rear upper arm mount (1 each on the left and right)
・ Aluminum rear knuckle (2 pcs)
・ Aluminum rear knuckle plate (2 pcs)
・ Aluminum suspension mount RF type # 3 (1 pcs)
・ Aluminum suspension mount # 3 (1 piece)
・ High rigidity upper arm pin (2 pieces)
・ Lightweight POM spacer (0.5 mm thickness x 4 pieces, 1.0 mm thickness x 4 pieces, 2.0 mm thickness x 2 pieces)
・ Aluminum Made of thin M3 nylon nut (2 pcs)
, turnbuckle M3 / M4 16 mm (2 pcs)
, turnbuckle M3 / M4 24 mm (2 pcs)
, aluminum spacer (Φ3 x Φ6 x 0.5 mm) (2 pcs)
, made of aluminum Spacer (Φ3 × Φ6 × 2.0mm) (4 pcs)
・ Aluminum spacer (Φ3 × Φ6 × 3.0mm) (6 pcs)
・ M2 × 5mm Cap screw (2 pcs)
・ M2 × 8mm Cap screw (4 pcs)
・Resin ball cap (1 piece)
, resin suspension mount bush (2 pieces)
, assembly manual (1 piece)
, development drawing / parts list (1 piece)

 

WE ARE A REVE-D DEALER! MORE REVE D PRODUCTS CAN BE SEEN BY CLICKING BELOW